Set up for your weight and terrain
Fork and shock servicing, sag measurement and settings matched to the rider, the bike and the riding.
Tell us your weight, riding style and what the bike does wrong, and we will explain how we tune it.
✓
Sag Set to Weight
✓
Fork and Shock Service
✓
Settings Written Down
About Suspension Setup
Electric dirt bike suspension tuning is about matching spring rates and damping to your weight, your riding and your terrain. E-motos are heavy for their size, so factory settings often leave the bike harsh in the chop or wallowing in the corners.

We start by setting sag. We measure how far the bike sits under its own weight and under yours in full gear, then adjust preload to get the balance front and rear that the suspension design expects. A correct sag setting changes how the bike turns, how the front end tracks and how much travel remains for bumps.
If your weight sits outside what the stock springs handle, preload alone will not fix it. We talk you through a spring rate change when the numbers say adjusting will not be enough, and we fit the springs. Tell us your riding weight and the gear you wear.

Fork and shock service is regular maintenance, and it is often overlooked on e-motos because the bikes feel quiet and gentle. Oil breaks down, seals weep and bushings wear, and the result is a harsh, uneven ride or a fork that stiffens after a few minutes. We service both ends of your bike so it rides the way it should.
We strip, clean and inspect, replace seals, bushings and oil as needed, then rebuild and set to the correct fluid levels. Seeing the condition of the internals also shows us how the bike has been treated, and we pass that on to you.

Once sag is right, we tune compression and rebound on the clickers so your bike settles quickly without packing down or kicking back. We change one thing at a time and test it, so each adjustment is understood and recorded.
We also check wheel and swingarm alignment, axle torque, chain tension and fork tube height, because a bike that is slightly out of line will never feel settled, no matter how good the settings are.
Tuning Steps
01
You tell us your weight, riding style, terrain and what feels wrong with the bike.
02
We measure static and rider sag and check fork, shock and linkage for wear.
03
We service the fork or shock where needed, then set preload and clickers.
04
We check alignment, axle torque and chain tension, then test the bike.
05
You get your settings recorded, so you can return to them or adjust from there.

Why Setup Matters
You get a bike that holds a line, absorbs hits without pogoing and gives you confidence into corners and over braking bumps. Fatigue drops too, because a well-set bike lets you ride loose instead of fighting it. Bring it to our Melbourne workshop and tell us where you ride.
We give you a set of written settings for sag, clickers and pressures, and explain what each does, so you can tune for new tracks or conditions without starting from scratch. Call 0438 690 440 to book.
Suspension Questions
Sag is how far the suspension compresses under the weight of the bike and rider compared with fully extended. Measuring it tells us whether the springs and preload suit you, and it is the base for every other adjustment.
It depends on use, but riders who race, ride often or ride in dust and mud should service more frequently than occasional riders. Check your manufacturer's guidance, and bring the bike in if it feels harsh or leaks oil.
Yes. Setup priorities differ from a dirt bike, with more focus on stability, braking dive and comfort, but sag, damping and alignment checks help any electric motorbike ride better.
Tuned Result
01
Sag set to suit you, so the bike turns predictably and neither end dives or squats more than it should.
02
Fresh oil and seals plus sensible damping soak up chop and square-edge bumps without hammering your hands and wrists.
03
A written note of sag, clickers and spring details so you can reset after changes or adjust for a different track.
Suspension FAQ
Tell us your riding weight and where you ride, and we will set sag, compression and rebound to suit you.